Fujitsu SPARC ENTERPRISE T5120 Instrukcja Użytkownika Pobierz pdf (Strona 29)

Important Information About the SPARC Enterprise T5120 and T5220 Servers 19

In the ILOM CLI, to set the locator LED to on or off:

prtdiag -v Voltage Indicators Section Has Non-Voltage

Indicators (CR 6587380)

Non-voltage indicators (such as PS0/TEMP_FAULT) will appear under the Voltage

Indicators section of the prtdiag output. The information reported under the

condition column is accurate and represents the current condition of the

components.

prtdiag -v Slow To Respond on 1U (CR 6588550)

The prtdiag -v command is slow and could thus appear to hang. It could take up

to five minutes for the command to complete.

Control-C from prtdiag, Blank Environmental Data Fields

When Run Again (CR 6552999)

When the verbose (-v) option is specified to the prtdiag command in the control

domain, additional environmental status information is displayed. If the output of

this information is interrupted by issuing a Control-C, the picld(1M) daemon may

enter a state that prevents it from supplying the environmental status information to

prtdiag from that point onward, and the additional environmental data will no

longer be displayed.

Workaround: Restart the picld SMF service in the control domain with the

following command:

-> set /SYS/LOCATE value=off

-> set /SYS/LOCATE value=Fast_Blink

# svcadm restart picl

1 2 ... 24 25 26 27 28 29 30 31 32 33 34 ... 57 58

Brak uwag

Fujitsu SPARC ENTERPRISE T5120 Instrukcja Użytkownika Strona 29