Fujitsu SPARC T5440 Instrukcja Użytkownika Pobierz pdf (Strona 135)

Servicing Customer-Replaceable Units 113

▼ Add FB-DIMMs

If you are upgrading the system with additional FB-DIMMs, use this procedure.

Before you begin, complete these tasks:

■ Read the section, “Safety Information” on page 63.

■ Read the sections, “FB-DIMM Configuration” on page 113 and “FB-DIMM Device

Identifiers” on page 116.

■ Power off the server using one of the methods described in the section, “Powering

Off the System” on page 67.

■ “Extend the Server to the Maintenance Position” on page 70

■ “Perform Electrostatic Discharge – Antistatic Prevention Measures” on page 73

■ “Remove the Top Cover” on page 73

■ “Remove a CMP/Memory Module” on page 104

1. Unpackage the FB-DIMMs and place them on an antistatic mat.

2. Ensure that the ejector tabs are in the open position.

3. Line up the FB-DIMM with the connector.

Align the FB-DIMM notch with the key in the connector. This ensures that the

FB-DIMM is oriented correctly.

4. Push the FB-DIMM into the connector until the ejector tabs lock the FB-DIMM

in place.

If the FB-DIMM does not easily seat into the connector, verify that the orientation

of the FB-DIMM is correct. If the orientation is reversed, damage to the FB-DIMM

might occur.

5. Repeat Step 2 through Step 4 until all the FB-DIMMs are installed.

Next Steps

■ “Install a CMP/Memory Module” on page 105

■ “Install the Top Cover” on page 154

■ “Slide the Server Into the Rack” on page 155

■ “Power On the Server” on page 157

FB-DIMM Configuration

This topic includes the following:

■ “Supported FB-DIMM Configurations” on page 114

1 2 ... 130 131 132 133 134 135 136 137 138 139 140 ... 211 212

Brak uwag

Fujitsu SPARC T5440 Instrukcja Użytkownika Strona 135